Technical Specification; Preparations - Carson SKY EAGLE Betriebsanleitung

Identification for GA-005
GB
1. Plug in a 15 - 18 V/ 1000 mA DC power at the input jack
(notice the polarity). The status LED is lighting in red.
2. When charging a 7.4 V Li-ion or Li-polymer rechargeable
battery pack, plug the pin of your battery into the 2 CELL
jack of your GA-005 in a certain direction. Then the charging
LED will become red and flashing, and this means the
battery has entered charging status. When your
rechargeable battery is fully charged, the LED will become
green.
3. When charging a 11.1 V Li-ion or Li-polymer rechargeable
battery pack, plug the pin of your battery into the 3 CELL
jack of your GA-005 in a certain direction. Then the charging
LED will become red and flashing, and this means the
battery has entered charging status. When your battery is
fully charged, the LED will become green.

Technical Specification

Output current: 750 mA
Input voltage: DC 15 - 18 V/ 1000 mA
End-of-charge voltage:
2 cell DC 7.4 V Jack
End-of-charge voltage 8.4 V
j. Preparations
General remarks
• If you have no or little experience with airplane models, you
should first practice with a Flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the
transmitter.
• Begin your flight experiments standing behind the model,
the line of sight in the flight direction. In this case, the control
reaction is the same as the direction of control.
Furthermore acquaint yourself with the control of the model as
it comes towards you (side-inverted reaction to the direction of
control)!
18 CARSON Helikopter SKY EAGLE 50 070 7042
3 cell DC 11.1 V Jack
End-of-charge voltage 12.6 V
Notice:
Every time only one group of rechargeable battery pack can be
charged. It is forbidden to charge two groups; otherwise your
charger or rechargeable battery will be damaged or burnt.
When the LED flash twice and then don't light circularly, that
means the rechargeable battery pack were broken.
Charging and installation of the airplane
batteries
Always charge the rechargeable battery outside the model on a
fire-proof surface.
1. Connect the battery charger with the battery adapter.
2. Plug the plug battery charger in a power socket.
3. Put the rechargeable battery in a metal bowl and connect
the battery with the battery charger.
4. Make sure that the connector is inserted correctly to avoid a
short circuit.
5. Do not cover the battery!
6. Do not charge unattended.
The temperature of the rechargeable battery should not exceed
60 °C during the charging process.
The charging process is finished when the green LED on the
balance charger lights up.