LaserLiner MultiWet-Master Bedienungsanleitung Seite 16

5
Measuring mode selection
The device features two different measuring modes.
Resistance measurement uses the test prods whereas
capacitive measurement uses the contact surfaces on
the underside of the device. You can switch between
both measuring modes with the „MODE" button.
6
Resistance measurement / material selection
Various types of wood and building materials as well as material-independent index mode can be selected
in resistance measuring mode. Measurements carried out in index mode are not material-related, i.e. for
materials, for which no characteristics are stored in the device. Select the required material by pressing the
„SET" button. The types of wood and building materials that can be selected are listed under 7 and 8 in
the following tables.
Types of wood: A, B, C
7
Material table - resistance measurement
1A Concrete C12/15
1B Concrete C20/25
1C Concrete C30/37
2 Cellular concrete (Hebel)
3 Limestone, density 1.9
4 Gypsum plaster
5 Cement screed
6 Cement screed,
bitumen additive
16 GB
Resistance
Building materials:
1,2,3.......,18,19
Building materials
7 Cement screed,
plastic additive
8 Ardurapid cement screed
9 Anhydrite screed
10 Elastizel screed
11 Plaster screed
12 Wood cement screed
13 Lime mortar KM 1/3
14 Cement mortar ZM 1/3
Capacitive
Index
15 Stone-wood, xylolite
16 Polystyrene
17 Soft fibre board wood,
bitumen
18 Cement-bonded particle
board
19 Brick