Connecting To Power - TomTom LINK 300 Installationsaleitung

EN

Connecting to power

Connect TomTom LINK 300 to the vehicle
Connecting to
power
power supply with the standard vehicle
voltage (12 V / 24 V). Do not connect to a
voltage converter. The three wires GND, IGN
and PWR+ (supply voltage) must be
connected.
1. Connect the GND wire (brown) to ground
(clamp 31).
2. Fuse the PWR+ wire (red) and the IGN wire
(black) with one 2 A / fast blow fuse each.
3. Connect the fused PWR+ wire (red) to the
carry current (clamp 30).
4. Then connect the fused IGN wire (black) to
ignition (clamp 15).
5. OPTIONAL: If you want to record a digital
input, connect the IN1 wire (green/blue) to
a 2 A / fast blow fuse, then connect the fuse
to a switch which is connected to the
power supply.
6. Insert the 4-pin plug into the power cable
connector.
12