Assembly.instructions; Fitting The Grip Tubing; Operation; Switching On And Off - FLORABEST FGH 710 A1 Betriebsanleitung

GB
splash water, and is made of rubber
or has a rubber covering. Only use
extension cables that are intended for
outdoor use and are labelled as such.
Use extension cables with a cable core
diameter of at least one square mil-
limetre. Always completely unwind the
cable reel before use. Check the cable
for damage.
• Use the cable hanger fitted for the pur-
pose when using an extension cable.
• Do not carry the tool by the cable. Do
not unplug the cable by tugging on it.
Keep the cable away from heat, oil
and sharp edges.
• If the power cable for this equipment
is damaged, it must be replaced with
a special power cable, which is avail-
able from the manufacturer or a cus-
tomer service agent of the same.
Assembly instructions
Always disconnect the tool from the
mains before conducting any work
on it.
While assembling the tool, make sure
that the mains cable does not be-
come caught and has enough slack.

Fitting the grip tubing

1. Push the two fork grips (1a/1b)
B
into the plastic cross-plate (4),
and screw the plate into the cor-
responding holes in the grip tub-
ing from behind using the bolts
provided (13).
2. Screw both central tubes (5) onto
the fork handles (1a/1b). To do
this, push the enclosed screws
(14) inwards through the holes
from the outside and screw them
in place with the wing nuts (15).
3. Position the handle rod with the
pipe ends to the left and right on
32
the lower frame tubing (
screw it in place with the enclosed
screws (14) and wing nuts (15).
When assembled correctly, the
handle ends point away from the
equipment front with the ventilation
slits (see 7).
4. Fasten the mains cable with the
cable clips supplied:
- Large cable clip (3a) above the
cross-plate
- Small cable clip (3b) at the
frame tubing.

Operation

Observe noise-abatement laws and
local by-laws.

Switching on and off

Note: Before switching the
tool on, make sure that the
tool is not touching any other
objects and hold it firmly in
both hands.
1. Plug the tool into the extension ca-
C
ble.
2. Loop the end of the extension cable
and hang it onto the cable tension
relief (16) to ease the tension on the
cable.
3. Plug the tool into the mains.
4. Hang the extension cable onto the
belt clip (12) and fasten it to your
trouser belt.
5. To switch on, press the safety re-
lease catch (17) and then squeeze
the dead-man lever (18). Release
the safety release catch (17).
The.tines.(
to.rotate.and.dig.themselves.
into.the.earth.
6. To switch off, release the dead-man
lever (18).
6) and
A
11).will.begin.
A