Intended Use - DeWalt D28715 Betriebsanleitung

If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.

WARNING: No connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data). The minimum conductor size is 1.5 mm
maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Package Contents
The package contains:
1 Chopsaw
1 Cutting disc
1 Hex key
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Bore Diameter
Date Code Position (Fig. A)
The Date Code 28 , which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A, G)

WALT
e
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Lock pin
1
Spark deflector screw
2
Spark deflector
3
Base
4
Fence
5
Vise
6
8 mm hex wrench
7
Crank
8
Vise lever
9

Intended Use

Your D28715 chop saw has been designed for the cutting of
variously shaped steel materials.
DO nOT use under wet conditions or in presence of flammable
2 ; the
liquids or gases.
The D28715 chop saw is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Young children and the infirm. This appliance is not
•
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
Connecting to the Mains
The mains supply to be used for this machine must be equipped
with a 16 A cut-out fuse with time delay.
Voltage Drops
In rush currents cause short-time voltage drops. Under
unfavourable power supply conditions, other equipment may
be affected. If the system impedance of the power supply is
lower than 0.25
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Wheel
10
Spark guard
11
Wheel lock lever
12
Trigger switch
13
Padlock hole
14
Extra blade bolt
15
Extra blade bolt washer
16
Quick-Change blade clamp
17
(Fig. G)
, disturbances are unlikely to occur.
EngLIsh
25