Kärcher SE 6.100 Originalbetriebsanleitung Seite 15

Wet cleaning of carpets/hard sur-
faces/upholstery
Health risk, risk of damage!
Check the object to be cleaned prior to using
the appliance in an inconspicuous place for
colour fastness and water resistance.
Do not clean water-sensitive floor coverings
such as wood floors (the moisture could pen-
etrate and damage the floor).
Notes:
Warm water (max. 50°C) will increase the
cleaning effect.
Only use detergent pump while operating.
Avoid dry runs as well as unnecessary pres-
sure buildup (dynamic pressure) as much as
possible.
In case of danger of overheating, the thermal
protection switch shuts off the detergent
pump. After cooling off (approx. 20 min), the
pump will be ready to use again.
Fill the fresh water reservoir
Illustration
You can remove the water reservoir to fill it.
Add 100 - 200 ml (volume depends on degree
of contamination) of RM 519 into the fresh wa-
ter reservoir, then add tap water - do not over-
fill (watch MAX marker).
Wet cleaning of carpeted floors

Use the wash floor nozzle.

Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
Wet cleaning of hard surfaces
Do not clean laminate or parquet floors!

Use the wash floor nozzle.

Slide the attachment for hard surfaces
onto the wash floor nozzle from the side.
Wet cleaning of upholstery

Use the wash hand nozzle.
Start working
Illustration

Insert the mains plug into the socket.

Press the switch for vacuuming, suction
turbine is running.
Illustration

Close fully the surrounding air separator
at the handle.
Illustration

Press the switch for spraying, the deter-
gent pump is ready.
Illustration

Use the lever on the spray handle to spray
on detergent solution.
Illustration

For continuous spray, the spray lever can
be locked; for this, activate the spray lever
and pull the locking key toward the rear.

Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Empty the wastewater reservoir during
operation

Once the wastewater container is full, the
appliance switches off automatically.
Note: Once the appliance shuts off,
switch off the appliance, because the suc-
tion turbine will otherwise start running
again once you open the appliance.

Release and remove the appliance head.

Remove the wastewater container and
empty it.
End wet cleaning process

Rinse the spray tubes in the appliance as
follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.
Cleaning tips/mode of operation
Always work from the light to the shade
–
(from the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
Rugs with jute backing can shrink if too
–
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
–
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care Tex
–
RM 762 after the wet cleaning prevents a
quick resoiling of the textile surface.
- 4
EN 15