teutonia Mistral P Bedienungsanleitung Seite 12

INT
Mistral P/Prestige
Using the Reclined Surface Extension
(available as an accessory)
If you need to, you can attach the washable bed exten-
sions at the foot of the sports buggy inlay using the push
locks.
Safety bar
Push the insert pieces on the safety bar through the
slots in the seat cover into the receptacles beneath,
which are located in the armrests. Make sure that the sa-
fety bar has clicked into place on both sides. To remove
it, press the release buttons on the insert pieces. In or-
der to make it easier for your child to get in and out, it
suffices to release and fold up one side of the bar.
WHEEL INFORMATION
We should like to mention a few points regarding our
pneumatic tyres:
1. Transport is most comfortable if the tire pressure is
1.5 – 2 bar (22 – 29 psi). If the tire pressure is lower,
there will be disproportionate wear on the tubes.
Caution: Always observe the maximum inflation pressure
stated on the tyres, which is reached quickly due to the
small volume.
Exceeding the pressure may cause accidents or injuries.
2. If the inner tube needs to be repaired or patched, use
either a common bicycle repair kit or a puncture spray
(e.g. as used for mountain bikes, mopeds, etc.).
To remove the tyre, use the two repair levers that are al-
ways included in any good bicycle repair kit. If necessary,
send the wheel to us via your dealer.
Special features of the model variations
Note: The brake should only be used to slow the wheels,
not to block them.
12
Models with deceleration
brake:
You are able to control the de-
celeration brake using the
brake on the handlebar. The
braking action can be fine-
tuned using the adjustment
screw on the brake lever.
Warning: When reordering rear wheels, please ensure
that the supplier is aware of the deceleration brake as
the brake requires a special brake disc. The foot brake
will not function if the wrong brake disc is used!
Maintenance:
-
The brake pads can wear out during use and the brake
needs maintenance. The setting of the brake can be do-
ne on the brake lever when the lock nut is loosened and
the adjusting bolt is unscrewed.
-
If the left and right braking effect differs, tilt over the
stroller on soft ground and adjust the bolt under the bra-
ke housings near the wheels.
-
The bolt can be screwed and unscrewed by using an
8mm jaw wrench. Unscrewing the bolt increases the
braking effect. The setting has to be made so that the
braking effect is the same on both wheels.
Shade holder on pram