Reading The Barometric Pressure; Reading The Barometric Pressure For The Last 12 Hours; Setting The Channel; Displaying The Outdoor Temperature - Auriol Z29536 Bedienungsanleitung

j
Press the HISTORY / WEATHER button
confirm your settings.
note: Ensure that you have set the current
weather correctly, otherwise the weather
forecast will not be correctly displayed.
j
The weather station starts with the weather
forecast approximately 6 hours after you
enter the current weather.
j
The weather station can display the barometric
pressure trend . You may see the following
25
displays:
= the barometric pressure will rise.
= the barometric pressure will remain
constant.
= the barometric pressure will fall.
Reading the barometric
Q 
pressure
j
Press the Relative / absolute barometric pres-
sure button to switch between the relative
30
and absolute barometric pressure display.
note: The display shows "Abs" if you have
selected absolute pressure. The display shows
"Rel" if you have selected relative pressure.
note: The absolute barometric pressure is
measured by the weather station.
j
Set the relative barometric pressure to the
barometric pressure relative to that at sea
level. Ask your local weather forecast service
for the barometric pressure at sea level.
j
Press and hold down the Relative / absolute
barometric pressure button
3 seconds.
j
Set the current barometric pressure by press-
ing the "+" / °C / °F button
"–" / MAX / MIN button
j
Press the Relative / absolute barometric
pressure button
30
Reading the barometric
Q 
pressure for the last 12 hours
j
Press the HISTORY / WEATHER button
to read the barometric pressure values for
the last 12 hours.
0HR = present barometric pressure
– 1HR = barometric pressure an hour earlier
– 2HR = barometric pressure two hours
earlier, etc.
= cloudburst /
storm
= rainy
27
for about
30
or the
28
.
29
to confirm your settings.
27
j
Press and hold down the "+" / °C / °F button
for about 3 seconds to switch between
28
displaying the barometric pressure units in
inHg or mb / hPa.

Setting the channel

Q 
The weather station receives the sensor signal
to automatically after you have made all the settings.
The field for the Outdoor temperature
during this time.
note: If you use more than one sensor (max. 3),
you can receive the data from each of the outdoor
sensors separately.
j
Set a different channel for each of the sensors.
j
To do this open the battery compartment on
the back of the outdoor sensor and take it off.
j
Set the channel by means of the Channel
selection switch
j
Press the TX button
temperature to the weather station manually.
The latter sounds an audible signal when it
receives the signal.
j
Then close the battery compartment
Displaying the outdoor
Q 
temperature
j
Press the Channel button
outdoor temperature of each outdoor sensor.
- Press the Channel button
channel 1.
- Press the Channel button
channel 2.
- Press the Channel button
channel 3.
- Press the Channel button
all the channels one after the other in a loop.
j
Press and hold down the Channel button
to remove unused channels. If a further out-
door sensor and channel are added later,
the weather station will receive the signal
automatically. Alternatively, you can also
transmit the initial signal from the outdoor
sensor manually by pressing the TX button
Displaying the temperature
Q 
trend (outdoor)
After successfully connecting with the outdoor
sensor, the weather station can display the
Temperature trend
You may see the following displays:
= The outdoor temperature is rising.
= The outdoor temperature is remaining
constant.
= The outdoor temperature is falling.
Operation
24
.
39
to transmit the measured
42
40
to display the
26
1 x to display
26
2 x to display
26
3 x to display
26
4 x to display
26
.
21
GB/IE
flashes
.
26
.
42
11