Data Recording - Sd Card - Weatherdock Easy TRX2S serie Handbuch

• WARNING
The warning LED flashes if e.g. for a longer period of time no GPS
data has been received. This LED is also on if the device is in
„Silent Mode", i.e. pure receiving mode .
• RX ONLY
This LED flashes together with the warning LED, provided that the
easyTRX2S-IS_Wifi is in pure receiving mode or "silent mode".
• AIS TX
This LED flashes each time when the device has sent an AIS
message.
• AIS RX
This LED flashes each time when an AIS message is received.
• All OK
This LED is illuminated permanently if all functions work properly.
20.2 DATA RECORDING – SD CARD
Also see point 17.5 on page 73
The easyTRX2S devices provide the possibility to record data onto a SD
card. All data rendered on the NMEA0183 and USB is recorded on a SD
card.
This means that all AIS messages (received and transmitted) are
recorded along with GPS information.
You do not need to take specific precautions regarding the recording.
Simply insert the SD card into the slot until you hear the snap. The
easyTRX2S starts recording automatically.
However, it is required to format the SD card with the Programming
tool at the first start. See "Chapter 18.5 SD card".
The user may analyze the recorded data with a specific PC software or
logbook software, which displays your own movement and the
movement of other adjacent ships.
If previous recordings exist on the card the new data is simply
attached. If the memory space on the SD card is full the oldest data is
overwritten successively. No data will be lost by switching off the
easyTRX2S. If you remove the SD card during recording some data
might be lost. Thus we recommend to switch the easyTRX2S off before
removing the SD card.
Weatherdock AG Sigmundstraße 180
Tel.: +49 911 376638 30
D-90431 Nürnberg
www.weatherdock.de
Page 96 of 108