Switch (Function Set By Software); External Devices (Additional); Buzzer - Weatherdock Easy TRX2S serie Handbuch

alert" next to an external signal generator for CPA alert and AIS
S.A.R.T.

19.5.2 Switch (function set by software)

The default value is set to silent mode. If you want to change the
function please do this by using the programming tool.
19.5.2.1 Silent mode „pure receiving mode"
According to the cable assignment under page 80, the brown and the
yellow cable of the 4-pole cable are destined for this functionality. If
these cables are connected to a SWITCH (not a BUTTON) e.g.
switchboard and short-circuit the cables with the button, i.e. connect
them the easyTRX2S Transceiver is set to pure receiving mode, i.e.
"silent mode".
By opening the switch the TRX2S resets to normal conditions
automatically, i.e. receiving and transmitting mode.
This function is preset by default with a switch on the easyCPA³ unit.
19.5.2.2 Anchor alarm
If you want to change the function to anchor alarm please open the
programming tool – see under 17.7. You can choose one function. If
the anchor alarm is active by set the switch to "1" and you drive out of
range of your set position the TRX2S set the output port of CPA to
high and an external buzzer e.g. easyCPA³ will switch on.

19.6 External Devices (additional)

19.6.1 Buzzer

There is the possibility, to connect the easyCPA³ as an additional
accessory. The device has predefined switches and buttons for the
above-mentioned functions. The easyCPA³ additionally has an external
signal generator for CPA alert and AIS S.A.R.T.
Based on the cable assignment under position 80 you may connect our
small external signal generator with the brown and white cable. This is
a device which is only suitable for CPA or anchor alert and AIS S.A.R.T.
Weatherdock AG Sigmundstraße 180
Tel.: +49 911 376638 30
D-90431 Nürnberg
www.weatherdock.de
Page 93 of 108