Multiplexer (Nmea-Input, 38400/4800 Baud); Commissioning Of An Easytrx2S Transceiver; Turning-On Of An Easytrx2S - Weatherdock Easy TRX2S serie Handbuch

Simply connect the corresponding colors.
When the CPA is connected the easyTRX2S devices send an alarm signal
to the switching output. The attached signal generator easyCPA
generates a loud and clearly audible alarm sound. This alarm sound
rings out at a CPA alert or if an AIS SART message is received.

19.6.2 Multiplexer (NMEA-Input, 38400/4800 baud)

You may connect a NMEA sensor (e.g. log, anemometer, etc.) with a
baud rate of 4800 or 38400 baud to the 6 pole cable of the pair of
conductors (brown/yellow) position 5 and 6. The sensor data is put out
to the plotter and PC together with the AIS and GPS data.
(Note: You cannot connect a GPS receiver as the easyTRX2S has its own
GPS receiver, and only these data can be interpreted and displayed at
the plotter or PC.
If you want to multiplex data from a 38400 baud device please set the
input baud rate with the programming tool.
You can find this under "static data" => "Mux-in"
20 Commissioning of an easyTRX2S
transceiver

20.1 Turning-on of an easyTRX2S

After the easyTRX2S Transceiver is connected according point 3 to the
12V supply and is switched on, all eight visible LED on the top of the
unit will illuminate once for a period of one second. Subsequently
every 2nd LED flashes for one second and after that the remaining LED
will be illuminated for one second.
Weatherdock AG Sigmundstraße 180
Tel.: +49 911 376638 30
D-90431 Nürnberg
www.weatherdock.de
Page 94 of 108