Marking Cutting Length; Marking Cutting Line; Connecting The Saw Dust Extraction; Replacing The Saw Blade - Parkside PTS 500 A1 Betriebsanleitung

Start-up / Maintenance and Cleaning / Service
3. Hold the machine as shown in Figure A and
cut with light pressure.
Types of saw blades:
The saw blades included cover the most common
types of application.
HW Circular saw blade
Description: ø 85 mm, 30 HW-teeth
Suitable for: Soft wood, hard wood, boards of any
type, plastics
Diamond cutting disc
Description: ø 85 mm, without teeth
Suitable for: Ceramics, plastics
HS Circular saw blade
Description: ø 85 mm, 36 teeth – tooth setting
left / right
Suitable for: Soft wood, soft metals such as aluminium,
copper, plastics

Marking cutting length

Orient yourself at the markings for the cutting
length , in order to check where your cut
8
starts and ends.

Marking cutting line

The cutting line viewing window allows precise
guidance of the machine along the cutting line
applied to the workpiece.
In order to achieve an exact cut, place the
machine on the workpiece so that the cutting
length labelling appears in the cutting line
viewing window
12
Connecting the saw
dust extraction
Push the extraction air hose
tion for dust extraction
28 GB
Z85 / 30:
20
Z85VR:
21
Z85 / 36:
22
, as depicted in Illustration B.
onto the connec-
19
.
14
Connect a vacuum device approved for the
extraction of sawdust and splinters to the dust
extraction hose .
19

Replacing the saw blade

1. Operate the spindle lock
clamping screw
18
turn clockwise). Now lift off the clamping screw
and washer and the clamping flange
18
(see also Fig.D).
2. Adjust cutting depth to the maximum position.
3. Swing the base plate
4. Take off the saw blade.
5. Refitting of the saw blade is the reversal of the
removal.
6. Operate the spindle lock
place) and, using the Allen key, tighten the
clamping screw
18
The arrow on the saw blade must coincide with
the arrow for the direction of rotation
(marked on the appliance).

Maintenance and Cleaning

DANGER OF INJURY! Re-
move the mains plug from the mains socket before
you carry out any work on the appliance.
Clean the appliance after finishing work.
To clean the appliance, use a cloth and do not
use petrol, solvents or cleaning fluids.

Service

repaired by qualified specialist per-
sonnel using OEM parts only. This ensures
that the safety of the device is maintained.
lead needs to be replaced, always
have the replacement carried out by the
manufacturer or its service centre. This en-
sures that the safety of the device is maintained.
and loosen the
13
with the Allen key (to open
17
upwards.
9
(until it clicks into
13
.
Have your appliance
If the plug or mains