Start-Up; Installing / Replacing The Saw Blade; Connecting The Saw Dust Extraction; Checking The Guard Function - Parkside PTSS 1200 A1 Betriebsanleitung

Start-up

Installing / replacing
the saw blade
Pull the mains plug out of the mains socket before
you carry out any task on the device.
1. Activate the switch lock
unit forward.
6
2. Release the locking lever
lock . The motor unit will lock into place.
1
3. The clamping screw / washer
in the cut-out .
14 b
4. Push the spindle lock
head wrench to undo the clamping screw /
5
washer .
14 a
5. Remove the saw blade
6. Install the saw blade
order.
The direction of rotation of the saw blade and
device must match.
Connecting the saw
dust extraction
Optionally attach the chip discharge adapter for
the dust extraction
Connect an approved dust- and chip extraction
system.

Checking the guard function

Note: for this process, place the baseplate at the
edge of a firm surface so the saw blade
lowered.
Lower the plunge saw.
Check if the saw blade
guard and if it independently returns to the
starting position.
and push the motor
1
. Release the switch
18
is now located
14 a
and use the socket
19
.
14
in the respective reverse
14
to the chip discharge
7
can be
14
rubs against the
14

Operation

Switching on and off

Switching on:
Slide the switch lock
Activate the ON / OFF switch
chine has started, release the start lockout
Switching off:
Release the ON / OFF switch
Adjusting the cutting depth
(plunge depth)
Loosen the screw on the depth adjustment
and slide the stopper to the desired cutting
depth shown on the depth scale
- without guide track see marking A.
- with guide track see marking B.
Tighten the screw for the depth adjustment
Note: adjust the cutting depth to the thickness
of the work piece. No more than one tooth
depth should protrude below the work piece.
Adjusting the cutting angle
(mitre square)
Loosen both adjustment wheels for the cutting
. angle .
17 11
Slide the motor to the desired cutting angle.
Tighten the adjustment wheels
Note: if the cutting angle adjustment for 0 ° or 45 °
moved, they can be readjusted with the micro-adjust-
ment screws
8

Note the cutting line

The saw stand
cutting line markings
Align the tool with the respective cutting angles
using the 0 ° resp. 45 ° cutting line marks
The slants are reference points.
Start-up / Operation
up and keep in position.
1
. Once the ma-
2
.
2
13
.
11
and .
8 a
is embossed with 0 ° / 45 °
9
.
9 a
.
1
12
:
.
12
.
9 a
GB/IE 11