Safety Notices For Chargers; Advice On Use; Before Use; Removing / Charging / Inserting The Battery Pack - Parkside PAMFW 10.8 A1 Betriebsanleitung

General safety advice for electrical power tools / Before use / Start-up
services providers. Contact with electricity
cables can lead to fire or electric shock.
Damaging a gas pipe can lead to an explo-
sion. Penetration of a water pipe can lead to
property damage or to electric shock.
I f you use the device outdoors, always
connect it through a residual current
device (RCD) with a maximum trip
current of 30 mA. If using an extension lead,
always use one that is approved for outdoor use.
Any harmful / noxious dusts
generated from sanding represent a risk to the
health of the person operating the device and
to anyone near the work area.
Wear safety glasses and a dust pro-
tection mask!
E nsure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
D o not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.

Safety notices for chargers

C hildren or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.

Advice on use

Principle of operation:
The oscillating motor allows the application tool to
oscillate back and forth 5000 to 19000 times per
minute. This allows for accurate working in the tight-
est of spaces.
Sawing / cutting:
U se only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
10 GB/IE/CY
W hen sawing lightweight building materials,
observe the statutory requirements and the
manufacturer's recommendations.
U se the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
E nsure that you use even contact pressure. This
will increase sanding sheet life.

Before use

Removing / charging / inserting
the battery pack
NOTE: The battery pack is delivered partly charged.
Charge the rechargeable battery in the charging
station for at least 1 hour before first use. This will
ensure the battery delivers full power. Li-Ion batteries
can be charged at any time without reducing the life.
Interrupting the charging process does not damage
the rechargeable battery.
1. To remove the battery pack
buttons and slide the battery pack
8
the unit.
2. Insert the rechargeable battery pack
rapid charger .
16
3. Insert the mains plug into the mains socket. The
status LED will light up red.
17
4. The green charging status LED
charging process has been completed and the
battery pack is ready for use.
9
5. Slide the battery pack

Start-up

Checking the battery charge

When the device is on, the battery status indicator
indicates the status or the remaining power as follows:
RED / ORANGE / GREEN = maximum
charge / power
RED / ORANGE = medium charge / power
RED = low charge – recharge battery
press the release
9
out of
9
into the
9
indicates the
18
into the unit.
9
2