Technical Data; Transportation; Transportation In Vehicle; Starting Operation - WAGNER PS 3.29 Betriebsanleitung

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Special high-pressure hose:
Dimensions (L X W X H):
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further. Insert
the handle – push the buttons (2) on the spars, and then push in the
handle.
2
3.7

Transportation in vehicle

Secure the unit with a suitable fastening.
ProSpray 3.29 ProSpray 3.31
220-240 Volt, 50/60 Hz
7.5 A 8 A
2
3 x 1.5 mm – 6 m
1725 Watt 1840 Watt
221 bar (22.1 MPa)
3.0 l/min 3.8 l/min
0.029 inch – 0.032 inch –
0.73 mm 0.81 mm
43°C
25.000 mPa·s
43.5 kg
DN 6 mm, 15 m, connection
thread M 16 x 1.5
590 x 529 x 726 mm
80 dB (A) *
1
2
GB
4.

Starting operation

4.1 High-pressure hose, spray gun and separating
oil
1. Screw the high-pressure hose (2) to the coating material
outlet (Fig. 3, Item 1).
2. Screw the spray gun (3) with the selected tip onto the high-
pressure hose.
3. Tighten the union nuts at the high-pressure hoses firmly so
that coating material does not leak.
4. Remove the oil cup cap with a straight-slot screwdriver.
5. Fill the oil cup with EasyGlide (Fig. 4) until the oil gauge (4) is
showing that it is full.
EasyGlide prevents increased wear and tear to the
packings.
Attention
6. Replace oil cup cap.
7. Press oil button 2-5 times to prime the oiler. Press once for
every eight hours of usage to lubricate the fluid section.
28
Starting operation
3
1
2
ProSpray 3.29 • 3.31