Description Of The Device - Stylies Libra Gebrauchsanweisung

English
congratulations! You have just become the proud owner of the extraordinary Stylies Ultra 240
Libra humidifier. You are sure to get a lot of pleasure from this device and it will improve the
air quality of your rooms.
as is the case for all electrical household devices, special caution is required when using this
humidifier in order for injuries, fire damage and damage to the device to be avoided. please read
through this instruction manual carefully before you use it for the first time, and adhere to the
safety guidelines on the device itself.

dEScRIptIon oF tHE dEVIcE

The device consists of the following main components:
1. Power cable for power supply
2. Steam pipe (fitted with bayonet lock, can be removed)
3. Upper housing
4. Lower housing
5. Water tank
6. On/off switch
7. Water level display
8. Hygrostat regulator
9. Spray output regulator
10. Device feet
11. Filter cartridge [Stylies Cartridge Reactor]
12. Ionic Silver Cube™ (optional)
13. Control display
FIRSt USE / opERatIon
Please note: never transport the device with a full water tank.
possible hazards:
- there is too much water in the base of the housing and the spraying power is severely re-
duced.
- water can escape
- the water tank can fall and become damaged (and water can leak on to the floor).
1. For this reason, base (4) of the Stylies Ultra 240 Libra humidifier should initially be placed
in a suitable location separately.
2. When this base is in the desired location: Lift off upper housing (3), remove water tank
(5) and fill with water (hold the filling opening slightly upright) Screw the lid back on firmly
and check that it is water-tight. Place the water tank back on the base, followed by the
upper housing. Insert steam pipe (2) on the upper housing. Plug power cable (1) into the
household power socket.
3. Switch on the Stylies Ultra 240 using on/off switch (6) and select desired power setting (9).
4. The desired air humidity can be selected using hygrostat regulator (8), from left (low hu-
midity) to right (high humidity). For example, if the regulator is turned completely to the left,
the device switches itself off at a relative humidity of approx. 30%, and only starts operat-
8