Heyner capsula BB0+ Bedienungsanleitung Seite 7

English
Index / page
1. Using the 0+ as a child´s car seat
capsula ® BB
0+ to your baby's size
2. Adjusting the
capsula ® BB
3. Installing the 0+ car seat into your car
capsula ® BB
4. Carrying Handle Positions
5. Care Instructions
6. Important Notices
Operating Instructions
A Seat shell
B Side belt guide
C Rear belt guide
D Carrying handle unlock
button
E Schultergurte / Hosenträger
E Harness belts / shoulder
belts
c -capsula.com
1
S. 2
S. 2
S. 3
S. 5
S. 5
S. 6
F Belt buckle
G Carrying handle
H Shoulder belt slots
I Belt adjuster
J Belt end element
N Diagonal belt
O Lap belt
P Belt latch
Q Belt buckle
0+
1. Using the
capsula BB
®
You have purchased the
capsula ® BB
for your trust. Please note, that the optimum safety characteristics can only be
achieved, if the seat is used properly according to instructions. Therefore we ask you
to ensure the correct installation of the seat in your vehicle by reading the operating
instructions carefully. Please keep instructions always with the seat for
further information.
Only to be assembled by adults!
2. Adjusting the
capsula ® BB
Fig. 1
The baby seat 0+ has its own belt system (E), a harness system,
capsula ® BB
which needs to be adjusted to your baby's size as follows:
0+ on a normal chair or on the floor and lay your baby inside.
Place the capsula BB
®
To ensure an optimal positioning of the belts, make sure that the harness belts (E) run
down from short above the child's shoulders (fig. 1c), not too high above them (fig. 1a)
and not too low (fig. 1b).
Attention: Never leave your baby unattended in the non-fixed baby seat!
Fig. 2
Thus you may adjust the height or level of the shoulder belts (harness belts):
Open the belt buckle (F) and pull the harness belts (E) through the shoulder belt
slots (H).
c -capsula.com
English
as a child's car seat
0+ car seat for your child. We thank you
0+
to your baby's size
GB
2