Replacing The Lamp; Troubleshooting - Electrolux EOB3434AAX Benutzerinformation

Make sure that you put the glass panels
(A and B) back in the correct sequence.
The first panel (A) has a decorative
frame. The screen-printing zone must
face the inner side of the door. Make
sure that after the installation the surface
of the glass panel frame (A) on the
screen-printing zones is not rough when
you touch it.
Make sure that you install the middle
panel of glass in the seats correctly.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
A B

10.9 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
A
4. Install the glass cover.
B
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
or deactivate the circuit breaker.
counterclockwise to remove it.
°C heat-resistant lamp.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
ENGLISH 25