Adding Oil; Initial Use; Connecting The Compressed Air Source; Switching On And Off - Parkside PDEXS 150 A1 Betriebsanleitung

Before Initial Use / Initial use / Working instructions
extraction. To do so, open the hook-and-loop
fastener at the side of the dust bag

Adding oil

To ensure a long service life for the compressed air
orbital sander the unit must always be adequately
filled with pneumatic oil.
You may ensure this in any of the follow-
ing ways:
Connect a service unit with an oiler to the
compressor.
Install a compressed air oiler in the air line or
to the compressor.
Manually add approx. 3-5 drops of pneumatic
oil to the plug nipple
minutes.

Initial use

Connecting the compressed
air source
Note: Only operate the compressed air orbital
sander with cleaned, condensate-free compressed
air. Never exceed the unit's maximum operating
pressure of 7.5 bar.
Note: The compressed air source must be fitted
with a (filter) / pressure reducer to allow the air
pressure to be regulated.

Switching on and off

Note: Always switch on the compressed air orbit-
al sander before bringing it into contact with the
work piece.
Switching on the compressed air orbital
sander:
Press the operating lever
(see Fig. C).
Adjust the speed with the speed control
36 GB
96905_par_Druckluft_Exzenterschleifer_content_DE_AT_NL.indd 36
.
10
every 15 operating
3
all the way down
1
.
5
Switching off the compressed air orbital
sander:
Release the control lever
Disconnect the unit from the compressed air
source after finishing the work.
Note: First disconnect the hose from the
compressed air source (compressor), only then
disconnect the supply hose from the unit. This
will ensure that the compressed air supply hose
does not wave around or recoil in an uncon-
trolled manner.

Working instructions

Wait until the device has come to a standstill
before you put it down.

Sanding surfaces

Switch on the compressed air orbital sander,
place the entire sanding surface on the surface
to be worked and move it across the work
piece with moderate pressure (see Fig. D).
Note: The sanding output and pattern greatly
dependent on the sanding disc selected and
the pressure applied. Only grinding discs that
are in perfect condition will provide good
grinding performance.
Be sure to apply pressure evenly to increase
the life of the sanding discs.
A sanding sheet previously used on metal must
not be used on other materials.

Replacing the backing plate

RISK OF INJURY! Always
disconnect the device from the compressed air
source before you replace the backing plate
Push the open-ended spanner
backing plate and collar
6
Release the backing plate
plate anticlockwise and holding the open-ended
spanner still against this movement.
11
.
1
.
6
between the
11
.
7
by turning the
6
30.04.14 15:46