Use; Dry-Ironing - Cleanmaxx SG5008S5 Gebrauchsanleitung

Otherwise, wait a few minutes when you adjust the device from a high temperature to
a lower level before you continue ironing.
• For an optimum ironing result, we recommend that you dry-iron the item of clothing
after steam-ironing it in order to remove the moisture from the clothing.

Use

CAUTION!
■ Never attempt to iron clothes while somebody is wearing them.
■ Risk of injury! Only hold the device by the handle when you are operating it.
■ Only iron on a stable, fl at, heat-resistant and moisture-resistant surface. We
recommend that you use a standard ironing board.
■ Do not iron on surfaces made from glass or plastic.
■ Always work with suffi cient lighting.
■ Always test the device fi rst on a small, inconspicuous spot on the clothing.
■ Never iron for too long on one spot to prevent damage to the clothing.
■ Do not iron over zips, studs, clips etc. to prevent any scratching of the ceramic
coating on the bottom of the iron.
■ Open the water reservoir cover only to fi ll the water reservoir. Otherwise keep the
cover closed while operating the iron.
■ Place the device on an even, stable and heat-resistant surface during and shortly
after use. Always place the device upright on its base to prevent damage to the
surface which could be caused by the hot bottom section of the iron.
NOTE: The fi rst time you use the device, you might notice a small amount of smoke. This
is harmless and will cease as you use the device.

Dry-Ironing

1. Move the steam quantity control (11) to position 0 and the temperature control (5) to
MIN. Turn the little wheel until MIN is next to the operating lamp.
2. Place the device to heat up upright on a stable, fl at and heat-resistant surface.
3. Plug the mains plug of the device into a properly installed mains socket that is easily
accessible. The operating lamp (4) lights up.
4. Check the label in the garment for the required ironing temperature and set this using
the temperature control. The temperature setting you want must be positioned next
to the operating lamp.
5. As the device heats up, the temperature control lamp (15) lights up. Wait until the
device has heated up and the temperature control lamp goes out. The device is now
ready for use and you can start ironing.
21 EN