Installation; Startup - Guntermann & Drunck MultiPower-6 Installationsanleitung

Installation

Installation
NOTE: The MultiPower-6
The maximum power consumption permitted per device is 1.2 A.
1. Use a power loop cable to connect one of the
compatible devices (12VDC/1.2A) to one of the
six Power Out sockets.
2. Connect one of the supplied power cables to the
socket.
Main Power
Connect the power cable to a power outlet.
3. If necessary, connect one of the supplied power
cables to the
Red. Power
redundant power supply.
Connect the power cable to a power outlet of another power circuit.

Startup

1. Turn on the power switch of the internal
2. Turn on the power switch of the internal
NOTE:
After you turn on the central power supply, the outputs are turned on suc-
cessively.
3 · MultiPower-6
supplies up to six devices with 12 Volt.
socket to establish a
Power Out 1
Status
12VDC/1,2A
power pack.
Main Power
power pack.
Red. Power
Power Out 2
Status
12VDC/1,2A