Carbon Filter - Respekta CH 22035 IXA Bedienungsanleitung

Before you switch your appliance on, check if the voltage of your energy supplier
meets the values on the model plate.
Do not connect the appliance to the mains if the values of the model plate do not
meet the values of your energy supplier.
If the appliance is not equipped with a plug, you must install a 2-pole plug which
meets all legal requirements with a contact opening of at least 3 mm. The installation
must be performed by an authorized professional.
Do not use a socket board or a multi socket when using 220 V – 240 V/50 Hz
alternating current (AC).All electrical connections which may be damaged
must be repaired by a qualified professional.
All repairs should be performed by your authorized after sales service.
1. Before you install any carbon filters: switch the appliance off and disconnect it
from the mains.
2. Remove the grease filters.
3. Insert the carbon filters on both sides of the motor (A) and fix them (B).
4. Replace the grease filters.
WARNING!

Carbon filter

54