Herunterladen Diese Seite drucken

PeakTech 1350 Bedienungsanleitung Seite 91

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

22. Technical Specifications
Unless otherwise specified, the technical specifications applied are for this oscilloscope only, and
Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions at first,
these specification standards can be reached.
This instrument should run for at least 30 minutes continuously under the specified operating
temperature.
If change of the operating temperature is up to or exceeds 5°C, do the "SelfCal" procedure in Utility
menu (see
Self
Cal).
Performance Characteristics
Bandbreite
Channel
Acquisition
Input
Horizontal System
Vertical system
Measurements
Communication port
Multi-function
Interface
Mode
Sample rate (real time)
Input coupling
Input impedance
Probe attenuation factor
Max. input voltage
Sampling rate range
Interpolation
Max Record length
Scanning speed (Sa/div)
Sampling rate / relay
time accuracy
Interval (△ T) Accuracy
(DC ~ 25 MHz)
A/D converter
Sensitivity
Analog bandwidth
Single bandwidth
Low Frequency
Rise time
DC accuracy
DC accuracy (average)
Waveform inverted ON/OFF
Cursor
Automatic
Waveform Math
Bandwidth
Lissajou
Phase
s figure
difference
Signal type
Level standard
Instruction
25 MHz
1
Normal, Peak detect, Averaging
100 MSa/s
DC, AC, Ground
10 MΩ ± 2%(X10), in parallel with 20pF±5pF
1 MΩ ± 2%(X1), in parallel with 20pF±5pF
1X, 10X
50 V (PK-PK)
0.5 Sa/s ~ 100 MSa/s
(sin x)/x
5 K
5 ns/div ~ 5 s/div, step by 1 ~ 2 ~ 5
± 100 ppm
Single:
± (1 interval time + 100 ppm x reading + 0.6 ns);
Average > 16:
± (1 interval time + 100 ppm x reading + 0.4 ns)
8 bits resolution
5 mV/div ~ 5 V/div
25 MHz
Full bandwidth
≥ 10 Hz (at input, AC coupling, -3 dB)
P 1350
± 3%
Average ≥ 16: ± (3% rgd + 0.05 div) for △ V
△ V and △ T between cursors
Vpp, Vmax, Vmin, Vtop, Vbase, Vamp, Vavg,
Vrms, Overshoot, Preshoot, Freq, Period, Rise
Time, Fall Time, +Width, -Width, +Duty, -Duty
FFT
Full bandwidth
± 3°
USB 2.0
Synchronizing input, Synchronizing output,
Pass/Fail output, External trigger input
TTL
-90-
≤ 14 ns (at input, Typical)

Werbung

loading