Inhaltsverzeichnis
Werbung
14.4 V — - - -
(FTC-1440K2)
230 V~
50 Hz
1.2 Ah (NiCd)
3 - 5
2
0-400/0-1150
/
0.8 - 10 mm
20 mm
10 mm
13 mm
1.66 kg
Lpa (
)
66.28 dB(A)
< 2,5 m/s
2
.
EN 60335,
.
(
)
.
.
,
.
mm
2
.
,
1
2
1
1
2
1
1
1
,
.
(
. )
1
/
2
3
4
5
6
56
,
.
•
(5a).
•
•
.
•
.
(
. )
•
,
•
,
.
.
90 .
•
(6)
.
1.5
.
OPERATION
Always observe the safety instructions and applica-
,
ble regulations.
.
Firmly hold the machine and push the bit with even pres-
(
.B)
sure into the workpiece. Do not force the machine.
Use only bits that do not yet show any signs of wear.
Worn bits have a negative effect on the efficiency of the
(5b)
machine.
.
ADJUSTING THE SPEED (Fig.D)
The machine has two different drilling speeds.
•
Set the speed selection switch (3) on position '1' for
drilling at a low speed.
•
Set the speed selection switch on position '2' for dril-
ling at high speed.
TORQUE ADJUSTMENT (Fig.E)
(2)
The machine has different torque settings by means of
which the force for fastening and loosening screws can be
.
determined.
•
Put the torque setting ring (4) at the required torque.
,
•
Preferably select the lowest possible setting to move
,
the screw. Select a higher torque setting when the
motor is slipping.
.
Screwing screws in and out
,
•
Set the direction switch (2) on position 'R' for putting
in screws.
•
Set the direction switch on position 'L' for removing
screws.
Drilling
•
Turn the torque setting ring (4) to drilling position.
Be sure that the direction switch (2) always in posi-
tion 'R' during drilling.
SWITCHING ON AND OFF (Fig.F)
•
Press the on/off switch (1) in. You regulate the speed
of the machine by the degree to which you keep the
switch pressed in.
•
Releasing the on/off switch (1) causes the drill to stop
immediately
•
Slide the direction switch (2) to the middle to lock the
machine in switched off mode.
Do not put the machine away until the machine has com-
pletely stopped running. Do not store the machine on a
dusty surface. Dust particles can get into the mechanism.
Ferm
Ferm
CHARGING BATTERIES (Fig. G)
The enclosed battery charger has been exclusively de-
signed for loading batteries of the FTC-1440K2.
•
Position the battery in the battery charger as indica-
ted in the illustration.
•
Plug in the battery charger. The red "fast charging"
light is then illuminated
•
As soon as the green light is illuminated, charging has
finished and the accumulator is ready for use
Only use the battery charger in a dry environment at
a temperature between 10 °C and 40 °C.
The accumulator on the drilling machine you have pur-
chased is not charged up. Before using it for the first time
leave it to charge for 5 - 7 hours in order for it to reach its
full capacity.
The total capacity of the accumulator will be reached af-
ter it has been charged 4 – 5 times.
5
Werbung
Inhaltsverzeichnis
