Threading The Machine - ELNA 2600 Bedienungsanleitung

z

Threading the Machine

To set the needle thread:
Raise the thread take-up lever to the highest position by
turning the handwheel.
Raise the presser foot.
WARNING:
Turn OFF the power switch before threading the needle.
Draw the thread from the spool and pass it under the
1
thread guide. Then draw it down along the right
channel.
Thread guide
1
Right channel
2
Draw the thread up around the bottom of the thread
2
guide plate.
Pull the thread up along the left channel
Thread guide plate
3
Left channel
4
Firmly draw the thread from right to left over the
3
thread take-up lever and down into the take-up lever
eye.
Thread take-up lever
5
Draw the thread down along the left channel and slip
4
the thread behind the needle bar thread guide from
the left.
Needle bar thread guide
6
Pass the thread through the needle eye from the front
5
or use the needle threader (refer to the next page).
30