Mode 1 "6 V" (7.3 V/0.8 A); Mode 2 "12 V" (14.4 V/0.8 A); Mode 3 "12 V" (14.4 V/3.8 A); Mode 4 "12 V" (14.7 V/3.8 A) - ULTIMATE SPEED ULG 3.8 B1 Bedienungsanleitung

NOTE
► If you press the MODE selection button
the charging mode automatically switches
to the next mode and begins operation in
that mode. If a 12 V battery is connected,
Mode 1 ( ) is not selectable. If a 6 V
battery is connected, Mode 2 ( ) 3 (
and 4 ( ) are not selectable. If a battery is
not disconnected from the charging station
after a full charge, the appliance remains in
trickle-charge mode, even if the user switches
over to another mode. This protects the fully
charged battery from being damaged.
Mode 1 "6 V" (7.3 V/0.8 A)
This mode is suitable for charging 6 V lead-acid
batteries with a capacity below 14 Ah.
♦ Press the MODE selection button
Mode 1 ( ). After doing so, the corresponding
LED display lights up. If you do not acti-
vate another process afterwards, the electronic
system will automatically activate together with
the LED display
process. If the procedure runs without any prob-
lems, the LED display
the entire charging process, until the battery
is fully charged to 7.3 V/± 0.25 V. When the
battery is fully charged, the LED display
lights up and the LED display
The appliance now switches automatically to
trickle charging mode.
Mode 2 "12 V" (14.4 V/0.8 A)
This mode is suitable for charging 12 V lead-acid
batteries with a capacity below 14 Ah.
♦ Press the MODE selection button
Mode 2 ( ). After doing so, the corresponding
LED display lights up. If you do not acti-
vate another process afterwards, the electronic
system will automatically activate together with
the LED display
process. If the procedure runs without any
problems, the LED display
during the entire charging process until the bat-
tery is fully charged. When the battery is fully
charged, the LED display
the LED display
│ GB │ IE │ CY
■ 6
,
)
, to activate
and starts the charging
remains on during
goes out.
, to activate
and starts the charging
remains on
lights up and
goes out.
The appliance now switches automatically to
trickle charging mode.
Mode 3 "12 V" (14.4 V/3.8 A)
This mode is mainly used for charging 12 V lead-
acid batteries with a large capacity of more than
14 Ah under normal conditions.
♦ Press the MODE selection button
Mode 3 ( ). If you do not activate another
process afterwards, the electronic system and
the LED display
the charging process. If the procedure runs
without any problems, the LED display
remains on during the entire charging process
until the battery is fully charged. When the
battery is fully charged, the LED display
lights up and the LED display
The appliance now switches automatically to
trickle charging mode.
Mode 4 "12 V" (14.7 V/3.8 A)
This mode is used for charging 12 V lead-acid
batteries with a capacity of more than 14 Ah in
cold conditions or for some AGM batteries with
a capacity of more than 14 Ah.
♦ Press the MODE selection button
Mode 4 ( ). If you do not activate another
process afterwards, the electronic system and
the LED display
charging process. In this mode, the charging
current is identical to that of "Mode 3" (
If the procedure runs without any problems,
the LED display
entire charging process until the battery is fully
charged. When the battery is fully charged,
the LED display
display goes out. The appliance now
switches automatically to trickle charging mode.
, to activate
will activate and start
goes out.
, to activate
will activate and start the
).
remains on during the
lights up and the LED
ULG 3.8 B1