(C) Installation Of The Door Bracket (8) - Rademacher Rp-Sx5-900N-3 Bedienungsanleitung

(C) Installation of the door bracket (8)

NOTE
We recommend xing the door bracket (8) to the door
frame if possible.
For plastic or thin-walled wooden doors, additional
cross-beams are necessary in order to avoid damag-
ing the door. In this case, consult your door supplier.
Use existing drillholes, if possible, to mount the door
bracket (8).
1. Place the door bracket (8) on the top edge
of the garage door and align it with the centre
of the door (in a line with the profile slide).
Next, mark out the four xing holes on the door
frame.
2. Punch in the fixing holes in the door frame
with the aid of the enclosed spike
NOTE
Self-tapping screws need sufficient hold in the
material. Check the thickness of your door frame.
If it is su ciently thick you can also pre-drill the
xing holes with a 4 mm metal drill bit if you are
not able to punch in the holes with the spike.
56
8
9
10
Key
8 = Door bracket
9 = Bolt (8 x 20 mm)
10 = Self-tapping hexagon screw (6 x 15 mm)
11 = Securing bolt (2 x 20 mm)
12 = Door connector, bent
RIGHT
Fixing hole made
using spike
The screw has
su cient hold
EN
11
12
WRONG
Fixing hole made
by drilling
The screw does not
have su cient hold