4.3
Main menu
Main menu
Submenu
UPS status
Event Log
Measurements
Control
"Buzzer Mute"
"Single UPS turn
off"
"Start Battery Test" Starts a manual battery test in individual mode
"Start Battery Test
Parallel"
"Clear REPO Sta-
tus"
"Reset Fault Sta-
tus"
"Clear Event Log"
"Reset Factory
Settings"
Identification
Settings
XS6000+XS10000_manual_ger_eng_it_V1.1.2.doc
Display information of the menu function
- Status information
- Warning/error messages (if existing)
- Battery status (status and charging status)
- Operating mode and running time
Displays up to 50 warning/error messages and
events. For more than 50 entries, the old en-
tries are overwritten.
- Load W | VA
- Load A | %
- Output V | Hz
- Line input V | Hz
- Bypass V | Hz
- Battery V | %
- DC Bus V | V
- Temperature °C
Switches off the audio alarm.
Switches an individual UPS system, which is
running in increase mode, into standby mode.
(see Testing the new batteries).
Starts a manual battery test in increase mode
(see Testing the new batteries).
Deletes the REPO status
Deletes the error list
Deletes the event list
Resets the settings to factory settings.
- UPS system type
- Serial number
- Firmware
Please refer to the Settings menu for details
Dry contact signal
input
Table 6.
Table 5: Main menu
101 / 216
O P E R A T I O N
"Enabled", "Disabled"
With relay card or AS400 interface "Ena
Recommendation: Adapt to requiremen
R. Kistler