Check Installation; Remove And Replace Seat Post And Saddle - Cube MTB Bedienungsanleitung

MTB/ Road Bike/ TRekking
62 |
•
placing the rear wheel under it so that the
chain is over the smallest sprocket
•
Carefully lower the rear of the bike until the
axle is at the dropout stop on the right and
left sides.
b) To assemble the front wheel
•
Lift up the bike by the handlebars,
•
placing the front wheel under the front forks
dropouts and
• carefully lower the forks until the axle is flush
at the dropout stops on the right and left
sides.
2. Tighten the wheel hubs.
• When tightening with quick releases: see
Chapter 8.8
3. Close rim brakes
a) on racing bike brakes:
Shimano und Sram:
•
Move the lever downwards.
b) Campagnolo:
•
There is no lever on the brake:
•
Follow the reverse procedure to opening
and press the pin on the brake lever from
outwards to inwards.
•
At the same time, pull the brake lever.
4.

Check installation:

•
Operate the brakes.
•
If the brake block or brake touches the rim
or the brake disks, this can indicate that the
hub has not been correctly seated in the
dropouts.
•
In that case release the quick release, check
and correct the hub seat and close the quick
release again.
•
The brake (on rim brakes) must not be
opened during this procedure. If there is no
improvement after this, please contact your
dealer immediately.
11.2 Remove and replace seat post
and saddle
Risk of Personal injury and
Material damage!
an incorrectly fitted saddle post can lead
to dangerous riding situations, falling,
accidents and material damage.
•
You must have your dealer demonstrate
fitting and removing your saddle post.
•
Practise this job at least once under his
supervision and control.
•
Only remove and fit the saddle post and
saddle if you are sure you have mastered
this job.
For transportation, you can remove your bike's
saddle post complete with saddle and replace it
again afterwards.
The saddle post is held with a clamp in the frame se-
at tube and is tightened with either a quick release
or a hexagon socket.
MTB/ Road Bike/ TRekking
On carbon fibre saddle posts, special types may be
fitted with two screws.
For clamping without a quick release, a hexagon
socket and a torque wrench of the appropriate size
are required. Please also consult your dealer.
To remove your saddle post:
1. Release the saddle clamp at the quick
release as per Chapter 8.8 or by loosening
the allen screw with an allen key.
2. Withdraw the saddle with saddle post
from the frame.
To replace your saddle post:
| 63