Brake; Frame And Suspension; Splash Guard - Cube MTB Bedienungsanleitung

MTB/ Road Bike/ TRekking
52 |
9.2

Brake

Risk of Personal injury and
Material damage!
The brakes on your bike are amongst the most important parts when it comes to your safety.
incorrectly functioning brakes can lead to dangerous riding conditions, falling, accidents and
material damage.
•
At the slightest problem and if the braking effect deteriorates, contact your dealer immediately.
•
Only ride the bike again after it has been properly readjusted by the dealer.
Problem Possible causes
Brake not correctly assembled
Brakes do not function
Brake damaged
Worn brake blocks or brake pads
Reduced braking effect, brake
Brake cable stretched, worn or
levers have to be pulled too far.
clamp/s damaged
On hydraulic brakes, brake system
leaking
9.3

Frame and suspension

Risk of Personal injury and
Material damage!
Frame and suspension faults may lead to dangerous riding conditions, falling, accidents and mate-
rial damage.
•
At the slightest malfunction, contact your dealer immediately.
•
Only ride the bike again after it has been properly readjusted by the dealer.
Problem Possible causes
Noises: Creaking, knocking, Frame and/or suspension
grinding or other. damaged
Tightening torque too low
The saddle post slips into the
In the case of frames and/or
frame or twists out of position.
saddle posts
made of carbon
Corrective action
Correct assembly as per Chapter 11.1
Contact a specialist workshop imme-
diately.
Have brake blocks or brake pads
replaced immediately in a specialist
workshop.
Contact a specialist workshop imme-
diately.
Contact a specialist workshop imme-
diately.
Corrective action
Contact a specialist workshop
immediately.
Check and correct the tightening
torque (see chapter 3.3).
Contact a specialist workshop imme-
diately.
Problem Possible causes
Incorrect assembly
The saddle post slips into
the frame or twists out of
The diameter of the seatpost is
position.
too small
Suspension has been set
Poor suspension response
incorrectly
Poor suspension response
Suspension
despite being adjusted
damaged
correctly
9.4 Splash guard, carrier and lighting system
Risk of Personal injury and
Material damage!
Splash guard, carrier and lighting system faults may lead to dangerous riding conditions, falling,
accidents and material damage.
•
At the slightest malfunction, contact your dealer immediately.
•
Only ride the bike again after it has been properly readjusted by the dealer.
Problem Possible causes
Noises: Creaking, knocking,
Splash guard or carrier parts loose Contact a specialist workshop immediately.
grinding or other.
Lighting elements (bulbs, LEDS)
burnt out
Lighting system partly or
totally dysfunctional
Wiring damaged
Dynamo defective
MTB/ Road Bike/ TRekking | 53
Corrective action
Dismantle and assemble correctly according
to point 11.2
Assemble a seatpost with the correct
diameter
Adjustment according to the accompanying
parts manual
Contact a specialist workshop immediately.
Corrective action
Replace lighting elements. Please consult
your dealer.
Contact a specialist workshop immediately.