End Of The Washing Programme; Standby Mode; Care And Cleaning; Clean The Filters - AEG Electrolux FAVORIT 52860 Benutzerinformation

36

Care and cleaning

End of the washing programme

Switch off the appliance in these conditions:
• The appliance stops automatically.
• The display shows 0.
• The end of programme indicator comes on.
1. Press the on/off button.
2. Open the door.
3. For better drying results, keep the door ajar for some minutes before you remove the
dishes.
Let the dishes cool down before you remove them from the appliance. Hot dishes are easily
damaged.

Standby mode

If you do not switch off the appliance at the end of the washing programme, the appliance
automatically goes into standby mode. The standby mode decreases energy consumption.
Three minutes after the end of the programme, all indicator lights go off and the digital
display shows one horizontal bar.
Press one of the buttons (not the on/off button), to go back to end-of-programme mode.
Care and cleaning
WARNING!
Switch the appliance off before you clean the filters.

Clean the filters

CAUTION!
Do not use the appliance without the filters. Make sure that the installation of the filters
is correct. If not, you have unsatisfactory washing results and damage to the appliance.
The appliance has 2 filters:
1. microfilter
2. flat filter
Do these steps to clean the filters:
1. Open the door.
2. Remove the basket.
3. Remove the filters in the bottom of the ap-
pliance.
4. Clean the filters under running water.
5. Put the filters back.
6. Turn the microfilter clockwise to lock.

Clean the spray arm

Examine the spray arm regularly. Remove food particles from the holes in the spray arm.