Pelgrim IDK640 Anleitung Seite 64

installation
126
Ventilation
De elektronica in het toestel heeft
kThe electronics in the appliance
require cooling. The ventilation
openings are located on the underside
of the appliance. It must be possible
for cool air to be drawn in through
these openings. The appliance is fitted
with outlet openings at the front and
bottom.
The kitchen unit will require a few modifications to allow optimum cooling of
the hob.
Above drawer or fixed panel
Saw out the ventilation openings (min.
100 cm 2 ). Ventilation is via plinth and
rear of cupboard.
Do not allow the ventilation openings
on the underside of the appliance to
be blocked by a drawer.
Where there is a drawer, a gap of at
least 560 x 6 mm should be made at
the front. The distance between drawer
A and the hob should be a minimum of
10 mm.
No extra modifications for ventilation
need be made where there is a fixed
panel.
min.
10 mm
min.
560 x 6 mm
150
A
installation
127
Ventilationprotection
The electronics in the appliance require cooling. The cool air is sucked from
behind the cupboard and blown out at the front and at the bottom in the front
of the appliance. The hob can only operate if there is sufficient circulation of
fresh air.
The appliance will switch off after a short time if there is not enough circulation.
See to it that the traverse lath does not hinder the airflow. Plane or saw the lath
oblique if necessary.
Above a 60 cm oven of the Pelgrim brand
Recess height minimum 600 mm.
Ventilation is via plinth and rear of
oven. Where there is a oven, a gap of
at least 560 x 6 mm should be made at
the front. Cut out ventilation openings
"A" + "B" (100 cm
in the side wall "C" of the kitchen
cupboard for leading the connection
cable through.
The hob may only be combined with Pelgrim ovens, not with combi-microwave
ovens.
Ensure that the connection cables hang freely. If there is a drawer underneath
the hob, make sure that the contents do not project above the edge of the
drawer and interfere with the ventilation.
B
2 ). Make an opening
C
600
A