Pelgrim IDK640 Anleitung Seite 63

installation
124
The next deviant connections are possible too:
1 phase connection
1 positive + 1 negative 1N a.c. 230 V
The fuse box in your home must be fitted with a 32 A fuse.
negative connection N (blue and
brown)
positive connection L (grey and
black)
3 phase connection
3 positive without negative 3 a.c. 230 V
The fuse box in your home must be fitted with a 16 A fuse.
positive connection L1 (grey)
positive connection L2 (black)
positive connection L3 (blue and
brown)
Safety prescriptions
For the appliance to work well, it is important:
■ That there is sufficient ventilation to allow the hob to cool down, in
accordance with the possibilities specified in this chapter.
The ventilation air drawn in by the hob must not be warmer than 35 °C. Bear
■
this in mind if the oven is to be built in under the hob.
■ That the connecting cable hangs freely and is not caught by a drawer.
The worktop should be a minimum of 2.8 cm and a maximum of 5 cm thick.
■
■ The worktop is flat.
grey
blue
brown black
yellow/green
N L
230V
blue grey
brown black
yellow/green
L3 L2 L1
230V 230V
230V
installation
125
Building in
Cut opening in worktop
Saw the opening in the worktop. This should be done very accurately (see
table). Also saw out any partitions that may be present. The distance from the
saw line to the rear wall and/or side wall is indicated in the table.
min.50
Table:
Type of hob
Appliance width x depth
Installation height from top of worktop
Cut out dimensions width x depth
Distance from saw line to rear wall
Distance from saw line to side wall
Space to be left free around the appliance:
604
512
48
560
490
IDK640
604 x 512 mm
48 mm
560 x 490 mm
Minimaal 50 mm
Minimaal 50 mm
cooker hood
min. 600 mm
cabinet
min. 650 mm
min. 450 mm
min. 40 mm min. 40 mm
Ceramic hob
side wall