Herunterladen Inhalt Inhalt Diese Seite drucken

Faults; Disposal Of Packaging And Appliances; Technical Data - Pelgrim idk 630 Anleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Faults

Please check the following points which may solve the problem, before calling the service
department.
Sympton
Cause
The appliance does not work.
No power supply.
The lights do not light up.
The cooking zones are not
Ambient temperature too low
working, the message F0
(5 °C) before the hob was
appears.
plugged in.
The fan switches itself on.
The appliance checks itself
after the loss of power.
The appliance stops suddenly.
Ventilator is not far enough
open.
The message F7 appears.
Transistors overheated.
The lamps continue to flash
An unsuitable utensil is being
after switching on.
used.
Poor electrical connection.
Appliance is locked.
Keep on/off button (E)
depressed for 3 seconds.
Fault codes F00 – F08 in the
A control is defective, dirty or
display.
has an object lying on it.
Action
Check the electrical installation
(fuse(s), connection).
After installation, wait about ten
minutes. The messages stop
flashing and you can then use
the appliance.
The fan switches itself off.
Check ventilator openings at
front and back.
Press any button. The message
disappears. Restart at a lower
setting.
Use a suitable utensil.
Check if the cable is being
caught by the drawer. If it is,
have it changed by the installer.
Clean the appliance or have it
repaired. Do not place objects
on the control panel.
Disposal of packaging and
appliances
The packaging of the appliance is recyclable.
It is made up off:
cardboard
polyethylene
CFC free polystyrene (PS rigid foam)
Please dispose of these materials in a
responsible way in accordance with the
regulations of your local authority.
Your local authority will also be able to give
you information about disposing disused
household appliances in a responsible way.

Technical data

Model number
IDK630
Energy supply
230 V, 50 Hz
Connection
5600 Watt
The identification plate is attached to the base
of the appliance.
The connection cable is of the type Y and may
only be replaced by qualified service
personnel.
This appliance complies with the CE directives.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis