Faults; Faults Table - Pelgrim GK466 Anleitung

6 Faults

Faults table

If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself fi rst by checking the points mentioned below in the
table or visit our website 'www.pelgrimservice.nl' for more information.
FAULT CAUSE
There is a smell of gas The gas connection of the
in the vicinity of the gas hob is leaking.
appliance.
A burner does not ignite. Plug not in socket.
Fuse defective/fuse in
meter cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas tap closed.
Fault in the gas network.
Gas bottle or tank is empty.
66
SOLUTION
Close the main gas tap.
Contact your gas fi tter.
Push the plug into the
socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the
sparkplug.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outfl ow holes are open.
Open the main gas tap.
Check with your gas
supplier.
Connect a new gas bottle
or have the tank fi lled.
6 Faults
FAULT CAUSE
A burner does not ignite. Wrong type of gas used.
Control knob not kept
pressed in far enough.
The burner does not burn Burner parts incorrectly
evenly. installed.
Burner parts dirty or damp.
Wrong type of gas used.
The burner goes out after Control knob not kept
igniting. pressed in long enough.
SOLUTION
Check that the gas used is
suitable for the appliance. If
not, contact your gas fi tter.
Keep the control knob
pressed in far enough
between full and low. At
fi rst use this can take some
more time because of the
gas supply.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outfl ow holes are open.
Check that the gas used is
suitable for the appliance. If
not, contact your gas fi tter.
Keep the control knob
pressed in for at least
5 seconds.
67