Faults; Faults Table - Pelgrim GK564 Anleitung

FAULTS

Faults table

Fault
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below in the table or visit our website
'www.pelgrimservice.nl' for more information.
Possible cause
The gas connection of the
gas hob is leaking.
Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas tap closed.
Fault in the gas network.
Gas bottle or tank is empty.
Wrong type of gas used.
Control knob not kept
pressed in far enough.
Solution
Close the main gas tap.
Contact your gas fitter.
Push the plug into the socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the sparkplug.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Open the main gas tap.
Check with your gas supplier.
Connect a new gas bottle or
have the tank filled.
Check that the gas used is
suitable for the appliance. If
not, contact your gas fitter.
Keep the control knob
pressed in far enough
between full and low. At first
use this can take some more
time because of the gas
supply.
EN 15