Herunterladen Inhalt Inhalt Diese Seite drucken

Prior To Use - Barbecook NASSAU INOX III 223.9022.000 Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
The following must be checked:
• The tank valve, including the threads into the tank (drawing C).
• Regulator fi ttings and tank connections (drawing C).
• All tank welds (drawing B).
• All hose connections (drawing D).
1. With a newly fi lled and tested propane tank attached to the barbecue and all the barbecue controls
turned OFF, slowly open the cylinder valve one full turn.
2. Using a brush and soap, soak all the connections and components listed above and shown in draw-
ings B, C, D.
3. Look carefully for bubbles forming, which is an indication of leaking gas.
4. Tighten the connections in the areas where the bubbles were visible until re-testing shows no indica-
tion of any leaks (shut off the cylinder while correcting any leaks).
5. Close the cylinder valve and ensure that all control valves are closed.
6. Do not use the barbecue if there are any leaks that cannot be stopped. Close the gas cylinder valve,
remove the gas cylinder and seek assistance from a qualifi ed gas appliance service mechanic or gas
dealer.
P RIOR TO USE
Do not use your barbecue until you have carefully read and fully understand all the information in this manual.
Please ensure that:
• Your barbecue is properly assembled.
• There are no leaks in the system (see "Leak Test").
• The burner is properly assembled, with the Venturi tubes seated over the valve outlets (drawing E), and that
there is nothing blocking the Venturi tubes (drawing F).
• All the power cords and / or gas supply hoses will not touch or be near the surfaces that will get hot.
• The barbecue is in a safe location (see installation).
Ensure that the valve outlets (orifi ces) are inserted approximately 6mm (1/4½') deep into the Venturi tubes, and
that the valve outlets and Venturi tubes are more or less parallel to the bottom of the lower body.
F
tubes with a brush or pipe cleaner. Replace the burner and ensure that the Venturi tubes are seated over the
orifi ces located on the gas valves. The Venturi tubes should be cleaned periodically, especially at the start of the
season.
Note: Damage resulting from blocked Venturi tubes is not covered by the warranty, and is regarded as inad-
equate maintenance.
|
16
www.barbecook.com
WARNING
Natural Hazards – insects and spiders
During shipment or storage, small insects such as spiders could
fi nd their way into the Venturi tubes and nest or make webs. This
could block the fl ow of gas through the Venturi tube, causing a
smoky, yellowish fl ame, or prevent a burner from lighting. It could
even cause the gas to burn outside the Venturi tube, which could
seriously damage your barbecue. If these occur, turn off the gas
fl ow and wait for the barbecue to cool down. When the barbecue
has cooled down, remove the burner and clean out the Venturi

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis