Herunterladen Inhalt Inhalt Diese Seite drucken

Lighting The Main Burner - Barbecook NASSAU INOX III 223.9022.000 Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
LIGHTING THE G RILL
Make sure you have followed all the checks, procedures and instructions indicated in the preceding sections
before attempting to light the grill.
• Always raise the barbecue lid before lighting the burner.
• Do not bend directly over the barbecue while lighting, in case of backfl ash.
• Making sure all the control knobs are 'OFF'. Slowly and carefully open the gas cylinder valve. Wait for about
fi ve seconds before opening the burner valve and lighting the barbecue. This procedure allows the pressure
to stabilise, and prevents activation of the fl ow control feature.

LIGHTING THE MAIN BURNER

• Important: Light only one burner!
• Once one burner is lit, the burner next to it can be lit by turning the control knob to "HIGH".
• Never light all burners at once.
USING THE IGNITOR TO LIGHT THE BURNER
• Raise the lid of the barbecue.
• Turn on the tank.
• Push in the control knob and turn it to the "HIGH" position.
• Push the ignitor button until sparks are being generated.
• If the burner does not light after three attempts, turn the control knob to the "OFF" position and wait for the
gas to clear (about 5 minutes). Repeat the aforementioned lighting procedure.
• If the burner still does not light, refer to the troubleshooting guide for help, or light with a long match as ex-
plained below.
G
MANUAL LIGHTING PROCEDURE
The barbecue has a small hole on the lower left and right side of the housing. These holes are situated towards
the front of the barbecue, and are used to manually light the barbecue (Drawing G).
• Raise the lid of the barbecue.
• Place a lighted match through the hole, to within 1,3 cm (0,51") of the burner.
• Turn on the tank.
• Push in the burner knob and turn it to the "HIGH" position. If the burner does not light within 5 seconds, turn
the control knob back to the "OFF" position and wait for the gas to clear.
• Wait for 5 minutes, and then repeat steps 1 to 4. If the burner still does not light after three attempts, consult
the troubleshooting guide for help.
www.barbecook.com
|
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis