J) Controlling The Vehicle - Reely 1400040 Bedienungsanleitung

j) Controlling the Vehicle

Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.
Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too
quickly at the beginning until you get used to the car's reactions. Do not make any quick and jerky move-
ments with the operating elements of the remote control.
The following figures are only to illustrate the functions and do not necessarily correspond to the design of
the transmitter provided.
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle

3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping

4. Drive forwards and then go into reverse (wait briefly between the change (approx. 1 - 2 seconds) and leave the
throttle/braking lever in its neutral position!)

40
Wait briefly