Fault Indications - Caso PRO 3500 Original Bedienungsanleitung

17.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Error Code
E01
E02
E03
E05
E06
E07
E08
► If error messages continue to be displayed after an extended waiting period or
after restarting the appliance, then it must be sent to Customer Service to be
examined.
caso Pro 3500
Cause
Supply voltage too low
(< 160 V)
Supply voltage too high
(> 270 V)
Possible short circuit
Overheat protection (in
power mode)
Temperature sensor
defective
Overheat protection (in
temperature mode)
Temperature sensor
malfunction
Please note
Solution
Ensure that the supply
voltage matches the voltage
shown on the type plate of
the device.
Ensure that the supply
voltage matches the voltage
shown on the type plate of
the device.
Please send the device to
customer service.
Remove the cookware and
allow the device to cool
down. Then turn the device
off and on again.
Please send the device to
customer service.
Remove the cookware and
allow the device to cool
down. Then turn the device
off and on again.
Please send the device to
customer service.
47