Safety Notices; Fault Indications; Causes And Rectification Of Faults; Disposal Of The Old Device - Caso Vario Power 3400 Chef 2253 Originalbetriebsanleitung

16.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

16.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display Description
E05 Overheating Protection
This means that the temperature had increased to a temperature of
150°C. In this case the device turns off automatically in order to avoid
damages.
In case of "E05" please pull the power plug in order to reset the device.
After this you can use it again as usual.
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.

16.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Display is empty
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

17 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment.
caso Vario Power 3400 Chef
Possible Cause
Power plug not plugged in
Fuse switch not switched on
Please note
To Rectify
Insert plug into mains
socket
Switch on fuse switch
Please note
44