Cleaning The Blender; Troubleshooting - Bosch MaxxiMUM MUMXX-Serie Gebrauchsanleitung

en

Cleaning the blender

Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Warning!
Do not wash blender holder in the dish-
washer or leave it in water.
Clean blender holder under running

water.
Lid, funnel and blender jug can

be washed in the dishwasher.
Note:
Lid can be disassembled for cleaning.
Fig. 
Pull funnel upwards out of the lid.

Press insert downwards out of the lid.

Tip: After processing liquids, it is often suffi-
cient to clean the blender without removing
it from the appliance. Pour a little water and
washing-up liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse
out the blender with clear water.

Troubleshooting

Risk of injury!
Before eliminating a fault, pull out the
mains plug.
The multi-function arm must be engaged
in each operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
Check the power supply.

Check the mains plug.

Check multi-function arm.

Correct position? Engaged?
Screw on bowl all the way.

Attach drive cover to unused drives.

The safety lock is active.

Switch appliance to 0/off and then back
to the required setting.
26
Fault
Appliance switches off during use.
The overload protection feature has been
activated. Too much food was processed
at one time.
Remedial action
Switch off the appliance and pull

out the mains plug.
Leave the appliance to cool down

for 15 minutes in order to deactivate
the overload protection.
Reduce processing quantity.

Do not exceed permitted maximum
quantities (see "Application examples").
Switch on appliance again.

If the motor still does not start, leave
the appliance to cool down for a longer
period (at least 1 hour).
Fault
The symbols on the automatic SensorControl
flash.
The automatic SensorControl could not
produce the defined result.
The appliance automatically switches off,
the rotary switch stops at 0/off.
Remedial action
Press any button on the automatic

SensorControl. The automatic system
is re-initialised. The appliance is ready
to use when all 3 symbols are lit evenly.
Move the rotary switch briefly to setting 7

until the result is as expected.
Check beforehand whether the cream
meets requirements (freshness, tempe-
rature) and the whisk has been set
to the correct height.
Fault
While the drive was running, the release
button was inadvertently pressed.
The multi-function arm moves up.
The drive switches off, but does not stop
in the tool change position.
Remedial action
Set the rotary switch to 0/off.

Move multi-function arm

to position 2.
Switch on appliance (setting 1).

Switch off appliance again.

Tool stops in tool change position.
Robert Bosch Hausgeräte GmbH