Herunterladen Inhalt Inhalt Diese Seite drucken

Battery Safety Precautions; Troubleshooting & Tips - SAGEMCOM D18V Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

D16V/D18V/D21V
Danger of explosion if battery is incorrectly replaced. Replace only with 2,4V 550mAh
type or equivalent rechargeable battery pack. Do not dispose of the battery in a fire.
The cell may explode. Check with local code for possible special
instructions.
13.1.

Battery safety precautions

- Do not burn, disassemble, mutilate or puncture. Like other batteries of this type, toxic
materials could be released which can cause injury.
- To reduce the risk of fire or personal injury, use only the battery listed in the user's guide.
- Keep batteries out of the reach of children.
- Remove batteries if storing over 30 days.
14. General product care
To keep your telephone working and looking good, follow these guidelines:
- Avoid putting the phone near heating appliances and devices that generate electrical
noise (for example, motors or fluorescent lamps).
- DO NOT expose to direct sunlight or moisture.
- Avoid dropping and other rough treatment to the phone.
- Clean with a soft cloth.
- Never use a strong cleaning agent or abrasive powder because this will damage the
finish.
- Retain the original packaging in case you need to ship the phone at a later date.
15. Troubleshooting
15.1.
Causes of poor reception
Aluminium siding.
Foil backing on insulation.
Heating ducts and other metal construction can shield radio signals.
You are too close to appliances such as microwaves, stoves, computers, etc.
Atmospheric conditions, such as strong storms.
Base installed in the basement or lower floor of the house.
Base is plugged into an AC outlet with other electronic devices.
Baby monitor is using the same frequency.
Handset battery is low.
You are out of range of the base.
15.2.
Troubleshooting tips
15.2.1. Caller id
No display
Problem
Is battery fully charged? Try replacing the
battery. Make sure the battery is properly
installed and connected.
If you are using AC power, make sure that the
unit is connected to a non-switched electrical
outlet. Disconnect the unit from the plug and
plug it in again.
Did you order Caller ID service from your
local telephone company?
- 23 -
disposal
Solution

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

D16vD21v

Inhaltsverzeichnis