SAGEMCOM D18V Bedienungsanleitung Seite 156

D16V/D18V/D21V
2. Using the
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_»
is replaced by a «*».
4. Press and hold
process the base goes back to standby).
5. Press key to confirm. The display shall show "WAITING" to indicate the waiting state.
6. Once the handset is registered, you will hear a confirmation tone. The handset automatically
exits the registering mode.
7. The handset number assigned automatically by the base appears on the screen.
9.3.
Disassociation of a handset
This function allows you to de-register a handset from your base.
1. Press . Select "advanced set" using the
2. Using the
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_»
is replaced by a «*». Press
4. Select the handset you want to delete (at standby state, "pls reg h/s" is displayed on the
screen).
You will hear a long beep confirmation tone.
9.4.
Modifying the country
1. Press . Select "advanced set" using the
2. Using the
3. Enter the base master PIN code (default 0000). Each time a digit is entered the «_» is
replaced by a «*». Press
4. Using the
5. A confirmation screen appears, press
The message "wait.." appears on the screen. You will hear a confirmation tone.
9.5.
Restoring the Handset / Base Default Settings
To restore the factory settings for your Handset or your Base:
1. Press . Select "advanced set" using the
2. Using the
3. A confirmation screen appears, press
- If you want to confirm the reset, press
- To cancel the reset, press
or key, select "registration". Press
key for 5 seconds (after 1 minute if no Handset has started association
or key, select "unregister". Press
key to confirm.
or key, select "country". Press
key to confirm.
or key, select the country where you will use the telephone. Press
or key, select "reset". Press
.
.
or key, press
.
or key, press
.
.
or key, press
.
.
.
- 15 -
.
.
.
.