SAGEMCOM D18V Bedienungsanleitung Seite 144

D16V/D18V/D21V
By default, your handset name and number are displayed on the idle screen. You can
change this display.
For this purpose, press and hold down the key
displayed on the screen
To return to the previous display, press and hold down the key
Place the handset in the base station to charge for 15 hours prior to first use. if you don't
properly charge the phone, battery performance will be compromised.
9. Plug one end of the telephone line cord into the modular wall phone jack and the other end
into the jack on the base.
10. After charging, press
Only use the supplied power adapter, connect it to the base socket according to the
installation instructions provided in this booklet and the indications on the identification
label affixed to it (voltage, current, electric network frequency). As a safety measure,
you can use the power adaptors to cut off the 230V current in case of danger. They
must be
2.3.
Handset keys
Screen
Access to dialled number
Access to menu /
Validate
Talk on
Handsfree *
Access to voice messaging service
(Press and hold) **
Activate, deactivate keypad lock
Recall/Flash
Microphone
* D21V only
** The voice mail number can be programmed. To change it, refer to « Assign a shortcut »
page 9.
.
key, you can hear dial tone.
located near to the device, and must be easily accessible.
: The current time and date are
- 3 -
.
Earpiece
Mute the microphone /
Correction / Cancel
Navigation key up /
Access the caller list
Talk off /
Switch handset on/off
Access to phonebook
Navigation key down /
Deactivate handset ringer
Internal call