Memory Status; Changing The Battery - SAGEMCOM D18V Bedienungsanleitung

12.2.2. Remote access control
To remotely access your answering machine: Dial your telephone number and wait for the
answering machine to come on.
When your outgoing message is played, press # and enter your remote access code (0000 by
default).
The code for remote access to the answering machine corresponds in fact to the
PIN Code of your Base. This code is 0000 by default, and it can be modified from
Note!
the "ADVANCED SET / CHANGE PIN" menu (refer to the paragraph "Base master PIN code"
page 14).
A beep will indicate access to the answering machine. You can carry out the following
operations:
1:
2:
3:
6:
8:
9:
12.3.
Selecting the answering machine language
You can choose the language of your answering machine. The messages will be played back in
the language you select.
1. Press
2. Select "settings" using the
3. Select "language" using the
4. In the list, choose the desired language using the
12.4.

Memory status

Your answering machine has a capacity of 15 minutes (2 minutes for the OGM and 13
minutes for the messages) or 59 messages.
When your answering machine reaches its maximum recording capacity, you can no longer
receive new messages.

13. Changing the battery

Make sure the telephone is OFF before you replace battery.
1. Remove the battery compartment door.
2. Disconnect the jack attached to the battery pack then remove the battery pack from the
handset.
3. Insert the new battery pack and connect the cord into the jack inside the handset.
4. Put the battery compartment door back on.
5. Place handset in the base to charge. Allow the handset battery to properly charge (for
12 hours) prior to first use or when you install a new battery pack. If you do not properly
charge the phone, battery performance will be compromised.
Previous message.
Listen to your messages.
Next message.
Delete the current message.
Stop the playback of the message.
Switch OFF the answering machine.
. Select "answ machine " using the
or
or
or , press
key , press .
key, press .
or
- 22 -
English
.
key.