Replacing The Fuse; Technical Specifications - EuroLite LED KLS-406 RGB DMX Bedienungsanleitung

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Number of DMX channels:
DMX-512 connection:
Number of 10mm LEDs:
Beam angle:
Sound-control:
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Dimensions (LxWxH):
Weight:
Accessories:
Foot switch for LED KLS Lightset
EUROLITE STV-40S Lighting stand, Steel
EUROLITE STV-40A Lighting stand, Alu
Please note: Every information is subject to change without prior notice. 21.10.2009 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
230 V AC, 50 Hz ~
120 W
21
3-pin XLR
1080
25°
via built-in microphone
45° C
60° C
0.50 m
0.10 m
F 2 A, 250V
1870 x 55 x 295 mm
10.5 kg
No.
42109710
59006996
59007001
22/22 00043659.DOC, Version 1.1