Herunterladen Inhalt Inhalt Diese Seite drucken

Standing Installation; Dmx-512 Control - EuroLite LED KLS-406 RGB DMX Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für LED KLS-406 RGB DMX:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

You must only use safety bonds complying with DIN 56927, quick links complying with DIN 56926, shackles
complying with DIN EN 1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the
carbines must be sufficiently dimensioned and used correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.

Standing installation:

Loosen the fixation screw of the lighting stand legs. Pull the legs out until the cross struts stand at a 90°
angle to the legs. Tighten the fixation screw of the legs.
Attach the LED KLS-406 RGB DMX to the top end of the stand and fasten the fixation screw.
Caution: The loads have to be installed in a balanced way.
Caution: The carrying capacity of the stand must never be exceeded!
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!

DMX-512 control

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR connection:
17/22
00043659.DOC, Version 1.1

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis