Replacing The Fuse; Technical Specifications - EuroLite LED MAT-64 DMX Bedienungsanleitung

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Sound-control:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Fuse:
Number of channels:
Number of LEDs:
Optional accessories:
EUROLITE TH-90 theatre-hook for 50mm pipe
Safety-rope 40cm x 3mm up to 10kg
Safety-rope 90cm x 3mm up to 10kg
Safety-rope 140cm x 3mm up to 10kg
Please note: Every information is subject to change without prior notice. 21.12.2006 ©
230 V AC, 50 Hz ~
23 W
via built-in microphone
280 x 240 x 225 mm
3 kg
: 45° C
a
(steady state): 50° C
B
F 0.5 A, 250 V
3
64
No. 58000720
No. 58010120
No. 58010130
No. 58010135
23/44 51918550_V_1_0.DOC