Safety Information; Intended Use; Qualification Of Personnel; Warranty - Mennekes Start (E) Betriebsanleitung

2.2

Safety Information

To recognise safety instructions in this manual at a glance,
the following signal words and symbols are used:
Danger
This symbol in conjunction with the signal word "Danger"
indicates an imminent danger.
Failure to follow the safety instructions will result in death or
serious injury.
Warning
This symbol in conjunction with the signal word "Warning"
indicates a potentially hazardous situation.
Failure to follow the safety instructions may result in death
or serious injury.
Caution
This symbol in conjunction with the signal word "Caution"
indicates a potentially hazardous situation.
Failure to follow the safety instruction may result in light or
minor injuries.
Caution
This note indicates a potentially harmful situation.
Failure to follow the safety instructions may result in
damage to, or destruction of the product and / or other
components.
2.3

Intended Use

The device may be used for the purpose described in
"Product Description" on page 4 and in conjunction with the
supplied and approved components.
Any use exceeding the aforementioned shall be deemed
unintended. MENNEKES assumes no liability for damage
resulting from non-intended use. The risk is borne solely by
the user / operator.
Intended use also includes:
 compliance with all the information in this manual;
 carrying out of servicing tasks according to schedule.
The device may present hazards, if it is not used as intended.
3
2.4

Qualification of Personnel

The electrical installation, setup and maintenance of the
device may only be performed by qualified electricians, who
have received authorisation from the system operator to
perform such tasks. Such persons must have read and
understood the operating manual and must comply with the
information therein.
Requirements of qualified electricians:
 Knowledge of general and special safety and accident
prevention guidelines.
 Knowledge of relevant electrical guidelines (e.g. DIN VDE
0100 section 600 DIN VDE 0100722), as well as valid
national regulations.
 The ability to recognize risks and avoid possible dangers.
2.5

Warranty

In the event of complaints regarding the product, please
contact your responsible service partner immediately and
provide the following information:
 type designation / serial number;
 date of manufacture;
 reason for complaint;
 duration of use;
 ambient conditions (temperature, humidity).
2.6

Returning Devices

In case you return the device to MENNEKES for repair, please
use the original packaging or a suitable, safe transport
container.